Version 1.0.1 Beta

V1.0.1 Release Notes:

Linear Bars Support
• Linear bars are now supported up to 30 minutes in length.

Be sure to reduce the Max Linear Bar Count in your chart settings before loading ScalperIQ to avoid performance issues.*

Core Fixes & Improvements
• Time frame changes now update properly.
• Replay mode resets cleanly when entering or exiting.
• Smart Mode no longer shows early-session low-intensity grey boxes.
• Composite futures like @NQ, @ES are now correctly recognized as futures instruments.
• Old performance settings have been deprecated— use MotiveWave’s Max Bars or Max Sessions based on your needs.
• Performance upgrades so that charts stay active and live while loading historical data.

Zones Revamped
• You can now extend zones from a specific session or range of sessions.
• All extensions now continue into the current session automatically.
• Zones now use advanced clustering logic to make sure you're seeing the highest intensity zones for the session.

IQBoost (New Feature)
• Adds improved accuracy for candle color direction matching.

Note: When IQBoost is ON, signal alignment between users may vary slightly due to local calculation differences. • When IQBoost is OFF, alignment across machines is possible (especially on linear bars using the same feed, time frame, and settings)

Flip Marker Alignment
• Flip marker misalignment has been significantly reduced.
• Some rare edge cases remain due to millisecond-level differences between data feeds.

Custom Themes
• We've added a Classic theme to our custom themes drop down for traditional red and green candles.

** If you have a high bar count set. ScalperIQ will still load, but it may take time to run the calculations on all historical bars. Your UI will remain active while this process is taking place and ScalperIQ will show its visuals once it is done with the calculations on all bars. If you accidentally put it on a chart with so many bars that load times are too high you can remove it from the chart to end the calculations, adjust your chart bar count, and replace it on the chart.

Note that the smaller the interval of time, the less likely your zones and markers will be synced with other user. MotiveWave natively allows for millisecond timestamps while Rithmic uses nanosecond timestamps. This rounding may drop 1 or 2 ticks into one candle for one user and another candle for another. This will not affect the overall accuracy of ScalperIQ, but may present with slightly different visuals for one user vs another. This is a limitation of MotiveWave, Rithmic, and how time stamping individual ticks is handled.